11 Nov 2026 - 1.5 hours

Tonight, I moved onto working on the pitot mast. I used the provided template to mark where the cutout on the skin needed to be. This took some careful measuring to make sure it was in the right spot because you only get one shot at this...

With the cutout marked, there was nothing left to do but start making a big hole in an expensive skin. I started with the step drill and got roughly close to the line.

Then I used the Dremel with a cutoff wheel to connect the holes.

After lots of careful filing and sanding with the Dremel sanding drum, I got a really nice fit around the pitot mast. Once it fit, I put the skin on the wing and then slid the mast in and match drilled it with the holes in the skin/spar. I also put two holes farther away from the spar on the aft end of the mast mount plate. I thought about adding a bracket to attach the mount to the rib as well, but that wouldn't really stiffen the mast up appreciably, so I didn't.