21 Nov 2026 - 3 hours

Well if I didn't get done what I set out to do yesterday! It was a nice day (almost 70 degrees) so I was able to get outside and shoot some primer on all four bottom skins!

Later in the day, I ran pull strings through both wing conduits and also cut a little hole in the conduit (you can see the little chunk missing in this picture). The hole is so that wires can escape the conduit here at the outboard-most inspection hole.

I also slogged through putting some fuel tank sealant on the conduits where it goes through the ribs. This is to keep it from chaffing and eventually wearing through the conduit. Seems like overkill but the instructions said to do it so I did it.

Slowly but surely, I'm checking things off the todo list so I can get to riveting on the bottom wing skins. I started tapping the wing tie-down holes tonight but my tap handle is absolute trash so I wasn't able to get that done on both wings (you can actually see it in these pictures of the left wing). I should be able to pick up a tap handle tomorrow and make quick work of that!